Turbelle® nanostream® electronic is a speed-controlled pump operating on safety extra-low voltage, to be employed ideally in every aquarium from 40 to > 1,000 litres (10 to > 265 USgal.) for simulation of lapping waves or tidal currents.
It contains a new microprocessor-controlled motor and thus can be called an “intelligent pump”: The electronic motor adapts its speed automatically to the pump load and always seeks the best efficiency at the lowest possible consumption of energy. This energy consumption is about fifty per cent lower than in conventional pump motors. The pumps will be stopped immediately in case of blockage. After the blockage has been removed, the pumps will start up automatically after a delay of 20 seconds. The pump driver has been provided with a fish care function, which causes a revolution of the propeller every twenty seconds when the pump is at a standstill.
It can be controlled by Multicontroller 7095, 7096 as well as Wavecontroller 7092.
Electronically controllable synchronous motor pumps - Turbelle® Controller included
The Turbelle® controller is a device that is used to set the variable pump performance. It can provide a wave simulation, oscillation flow, an automatic search for the resonance frequency when the oscillation flow is used, and it is also equipped with a food timer. It can be directly connected to a Multicontroller / SmartController 7000. The pump is therefore able to operate together with other pumps, for example, in the high/low tide mode. If the Moonlight 7097.050 (not included in the scope of delivery) is attached to the Turbelle® controller, the night-mode operation will be activated automatically. If this controller is connected to a second controller with the 7092.300 cable, a further pump can be connected and controlled, for example, to provide a wave pounding simulation or an oscillating current. A third controller can be added using the Y adapter cable 7090.300.
Turbelle® nanostream® 6095
(6095.000)
WIDE FLOW
for aquariums from 100 to 1000 litres
(25 to 265 USgal.).
Flow rate: 2,000 to about 9,500l/h
(550 to 2,500 USgal./h)
with Turbelle® Controller
Energy consumption: 5 - 21W
Power supply unit: 240V / 50Hz
Cable length: 5m (196.8 in.)
Dimensions: diam. 70mm (2.7 in.)
Output: diam. 50/10mm (1.96/.39 in.)
Magnet Holder with Silence clamp up to a glass thickness of 15mm (1/2")
